Air Conditioning Installation in Calamvale, Brisbane

Property: 1998 two-storey brick veneer, ground-floor open-plan living, kitchen and dining approximately 55sqm. Job: New 9.0kW reverse-cycle split system, living area. Required 32-amp dedicated circuit. Challenge: Larger-capacity unit required a 32-amp circuit — new circuit run from switchboard completed within the installation. Indoor unit position selected to maximise airflow coverage across the full depth of the open-plan area, avoiding the kitchen island obstruction. Outcome: Completed in 5 hours including electrical work. Previous cooling for the living area was a 6.0kW unit that had never adequately covered the full space. New 9.0kW unit cooled the entire area evenly — no more hot spots near the kitchen.

Property: 2001 two-storey brick veneer, master bedroom (20sqm, first floor) and ground-floor home office (14sqm). Job: 3.5kW master bedroom + 2.5kW home office, installed same day. Challenge: First-floor master bedroom required pipe run down the external rear wall. Home office had been converted from a formal dining room — no existing circuit for air conditioning. New circuit run for home office unit included in the installation. Outcome: Both units completed in 4.5 hours. Homeowner works from home full time — home office comfort in summer was the primary driver. Master bedroom addressed in the same visit for efficiency.

Property: 2005 two-storey townhouse, ground-floor living area 28sqm. Body corporate approval pre-obtained. Job: New 6.0kW reverse-cycle split system, living area. Challenge: Body corporate required all external pipe runs to be concealed in matching duct casing. Outdoor unit positioned on ground-floor slab at rear within the body corporate-approved zone. Installation approach confirmed with body corporate requirements before booking. Outcome: Completed in 3.5 hours. External pipe run fully concealed — duct casing colour matched to external render. "You can barely tell anything was installed," was the homeowner's observation.